308 constitution drive menlo park, ca 94025-1164 phone: 800-227-4856 www.circuitprotection.com polyswitch? ptc devices overcurrent protection device product: AGRF1100 document: scd25238 pcn: d14148 rev letter: c rev date: may 13, 2011 page no.: 1 of 2 specification status: released electrical rating voltage: 16v dc max insulating material: cured, flame retardant epoxy polymer lead material: 20 awg tin plated copper (0.8 mm [0.032] nom. diameter) part marking: manufacturers mark and voltage lot identification part identification gf11 (can be on back) 16 table i. installation envelope dimensions: a b c d e f g min max min max min max min max min max typ min ma x mm: -- 17.5 -- 26.5 4.3 5.8 7.6 -- -- 3.0 1.2 -- 7.47 in*: -- (0.69) -- (1.04) (0.17) (0.23) (0.30) -- -- (0.12) (0.05) -- (0.294) *rounded off approximation table ii. performance ratings: current ratings time to trip initial resistance r 1 max 1 hr. post trip resistance standard trip r a max tripped- state power dissipation amps at 25c seconds at 25c, 55 a ohms at 25c ohms at 25 ? c ohms at 25 ? c watts at 25c hold at r 1 max hold at r a max trip max min max typ 11.0 10.5 20.3 7.5 0.0033 0.0060 0.0089 0.0093 3.7 reference documents: ps400, ps300 (reference for r 1 max ) precedence: this specification takes precedence ove r documents referenced herein. effectivity: reference documents shall be the issue in effect on the date of invitation for bid. caution: operation beyond the rated voltage or curr ent may result in rupture, electrical arcing or fla me. materials information rohs compliant elv compliant pb-free
308 constitution drive menlo park, ca 94025-1164 phone: 800-227-4856 www.circuitprotection.com polyswitch? ptc devices overcurrent protection device product: AGRF1100 document: scd25238 pcn: d14148 rev letter: c rev date: may 13, 2011 page no.: 2 of 2 table iii. automotive specific stress tests and tes t conditions: electrical stress tests test conditions (see note 2) esd voltage withstand (see note 1) 25kv short circuit fault current durability 25 cycles, 1 6v, 200a fault current durability 350 cycles, 16v/100a end-of-life mode verification 1750 cycles, 16v/100a jump start endurance (see note 1) 3 cycles, 26v, 1 minute duration load dump endurance (see note 1) 10 cycles, 86.5v note 1: the polyswitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the polyswitch device and the load r esistance as specified in ps400. note 2: please refer to appendix a of ps400 for the detailed test procedures ? 2004, 2011 tyco electronics corporation, a te c onnectivity ltd. company. all rights reserved.
|